Contact Us

Shandong Aonuo New Material Co,.Ltd

Add: Guangrao County, Dongying City, Shandong, P.R.China

Tel:+86-546-6660612

Fax:+86-546-6660279

Ph:+8613287307852

E-mail:info@aonuochina.cn

Connection between proportioning pump and gun

- Oct 22, 2018 -

Connect one end of 15M high-pressure heat preservation feed tube with the discharge hole of proportioning pump and the other end with the feed hole of the gun. Connect one end of feed pipe with red label with the discharge hole of black feed proportioning pump and the other end with the pipe joint of feed pipe at the left side of the gun. Connect one end of pipe joint of feed pipe with blue label with the discharge hole of white feed proportioning pump and the other end with the pipe joint of feed pipe at the right side of the gun.


Notes: do not connect the discharge hole of host machine with all pipe joints of the feed pipe of the spray gun with the flexible cord. For the insulation is necessary to connect circuit. Otherwise, the short circuit will be resulted. As a result, after the partial pipe is heated, the temperature is exceeded. Thus, the explosion of the pipe might be resulted.


Related Industry Knowledge

Related Products

  • DETDA Equivalent To Ethancure-100
  • Chain Extender For Polyurea Coating
  • Hydraulic Polyurea Spray Equipment
  • One Component Polyurea Rein-forced Concrete Anticorrosion Waterproof Protective Coating
  • Floor Special Polyurea Wear Resistance Anticorrosion Protective Coating
  • Polyurea Elastomer Is A Two-component